22-10-09, 03:53 PM
Well im studying a general electrical and electronic engineering course at the moment but i hope to go into something to do with power and control systems.
Programming micros is hard. Im currently programming a PIC18F4520 in C, using MATLAB.
But im sure reading from a 0-5v potentiometer and outputting it to two 7 segment displays, so that when you twist the pot, it counts up in hexadecimal on the displays is easy for you
(dont worry if no-one else understood some of that!
)
Programming micros is hard. Im currently programming a PIC18F4520 in C, using MATLAB.
But im sure reading from a 0-5v potentiometer and outputting it to two 7 segment displays, so that when you twist the pot, it counts up in hexadecimal on the displays is easy for you
(dont worry if no-one else understood some of that!
My friends call me Hadouken! Cause im down, right, fierce!


